My Shopping List Use the Paint Calculator to add the required amount of paint to your shopping list.



The Taubmans Tradex Interior Walls range has been specifically formulated for the trade painter. They are easy to apply via spray brush or roller, provide excellent coverage and varying sheen levels for the answer to every surface.

Interior walls where you want a smooth washable finish with a low side sheen, exterior eaves

Excellent opacity
Washable finish
Easy to apply by spray, brush or roll

Colour Range
White and colours tinted from White, as indicated on Taubmans Consumer or Architectural/Specifier Colour Systems. Not all colours are suitable for two coat cover. Refer to your local representative for advice.
Drying And Recoating
Touch dry in 30 minutes (at 25°C and 50% relative humidity). Recoat after 2 hours with oil or water based topcoats. Note: Drying time may be lengthened in damp, cold or humid conditions.
Specifications met
APAS 0260/3 approved

Surfaces must be clean, dry and free from all surface contamination. Wash down the surface with detergent, followed by a rinse with clean water. Treat mould with bleach then rinse with fresh water. Fill in surface defects such as cracks or holes with a suitable filler, putty or sealant.

Stir paint well in a circular lifting motion for 5 minutes before use with a broad flat paddle. Apply one coat of Tradex UltraPrep (where required) and two coats of Tradex topcoat (Ceiling, Matt, Low Sheen or Semi-Gloss) by using a good quality brush and roller sleeve (12mm for Ceiling, Matt & Low Sheen; 8-10mm for Semi Gloss). Extra coats may be required for application by brush only. It is also important to avoid using poor quality or worn rollers and brushes as they can adversely affect the final finish. Spray Application: Airless Spray or HVLP. Thin up to 10%.

Approximately 16m² per litre depending on the nature of the surface. Coverage on rough and/or porous surfaces will be lower.
During Painting
Keep floors and furniture covered. Ensure adequate ventilation during application and drying. Keep the lid on containers when not in use. Do not paint when temperature is below 10°C, or above 35°C. Keep the container sealed when not in use.
After Painting
Avoid exposure to steam & condensation for 48 hours. Surfaces may be washed after 7 days.