Easycoat ceiling pink to white
Available in: Flat
Ideal for all ceilings. Gloss Level 1%
Preparation and directions
Easy Coat Ceiling Pink to White applies pink and dries to a flat white in 2 – 4 hours depending on weather conditions, to allow visibility of painted areas.
Surfaces must be clean, dry and free from all surface contamination. Treat mould with bleach then rinse with fresh water. Fill in the surface defects with suitable filler, putty or sealant. Avoid using masking tape on wall and ceiling paints.
Paper Faced Plasterboard, Fibre Cement, Masonry & Timber – Apply one coat of Taubmans Easycoat Prep Sealer/Primer/Undercoat.
Plaster – Seal with one coat of Taubmans PrepRight Plaster Sealer.
Previously Painted Surfaces
Remove all loose and flaking paint by scraping or sanding previously painted areas and sand smooth.
- Undercoat previously painted enamel surfaces with Taubmans 3 in 1 to promote intercoat adhesion.
- Spot prime bare areas in accordance with directions for new work.
Apply two coats by roller or brush. Paint the corners and edges with a narrow brush and roll up to the edges using a 10mm (length of nap or pile) roller.
- Stir paint in a circular lifting motion for 5 minutes before use
- Drying time: 30 minutes (touch dry)
- Recoat: 2 hours at 25°C (allow 4 hours in cold or humid areas)
- Do not paint at temperatures below 10°C
Up to 16m² per litre. Coverage will be lower on rough or absorbent surfaces.
Ensure adequate ventilation, keep floors and furniture covered. Keep the lid on containers when not in use.
Discover more at thecleanerhome.com