Alkyd Based - Ultimate Enamel
Available in: Gloss, Semi-gloss
Ideal for interior and exterior doors & trims. Gloss level 90%. VOC level less than 50g/L.
Ideal for all interior doors and trims. Gloss level 40% - 50%.
Preparation and Directions
Surfaces must be clean, dry and free from all surface contamination. Treat mould with bleach then rinse with clean water. Fill in the surface defects with suitable filler, putty or sealant. Avoid using masking tape on wall and ceiling paints.
Paper faced plasterboard, fibre cement, masonry and timber: apply one coat of Taubmans 3 in 1.
Previously Painted Surfaces
Remove all loose and flaking paint and sand glossy or enamel surfaces thoroughly. Prime bare areas with Taubmans 3 in 1. To ensure an even surface when painting over patchy or contrasting colours apply Taubmans 3 in 1. For previously painted enamel surfaces undercoat with Taubmans 3 in 1.
Confirm colour before use. Apply two coats using a 5mm (length of nap or pile) roller or good quality brush. Avoid overspreading. If painting a large flat trim area, such as a door, apply by roller for best appearance.
- Stir paint in a circular lifting motion for 5 minutes before use
- Drying time: 1 – 2 hours (touch dry)
- Recoat: 4 - 6 hours at 25°C (allow an hour longer in cold or humid areas)
- Do not paint at temperatures below 10°C
Up to 10 - 12m² per litre. Coverage will be lower on rough or absorbent surfaces.