Satin

Medium Black Texture Roller

Datasheet Number: D245

A smooth, low gloss, acrylic membrane with outstanding long term durability. This easy to apply finish is highly weatherproof and ideally suited for high rise repaints and as a dirt shedding or impact coating for masonry surfaces.

Product Overview

Description

A low gloss, tough acrylic membrane with outstanding long term durability.

Uses

Repaint/impact coating on masonry, brick/blockwork. Exterior cement render, concrete, fibre cement sheeting, AAC panels and blocks, bricks and blockwork. Recommended for texture coating repaint or as an impact coating. Particularly suitable for commercial and high rise repaint where a weatherproof membrane is required.

Features & Benefits

Seamless membrane

Outstanding weathering and moisture resistance.

Vapour permeability

Allows substrate to breathe.

Technical

Colour range

Available in a wide range of colours.

Dry Film Thickness

80 – 100 micrometers, depending on profile.

Colour range

Armawall Primer – 2 Hours. Armawall Armashield – 4 Hours.

Note: This may be lengthened in damp, cold or humid conditions. Do not apply at temperatures below 10°C.

Odour

Low

Profile

Low

Surface Preparation

New cement render, masonry and concrete surfaces

New cement render, masonry and concrete surfaces should be allowed to cure for 28 days until the alkalinity is below PH10. Off form concrete should be thoroughly cleaned by acid etching, water or sand blasting to ensure all bond breaker oils are removed. All masonry surfaces should be primed with Armawall Primer (thinned 50-100% with water) prior to the application of Armawall Satin. Remove bondbreaker from tilt slab concrete and seal with Armawall Sealer/ Bonder to ensure adhesion of topcoats.

Previously painted surfaces – in sound condition

Previously painted surfaces in sound condition should be scrubbed down with detergent and fresh water, fresh water washed and allowed to dry.

Previously painted enamel surfaces

Previously painted enamel surfaces should be undercoated with Taubmans Tradecoat. Surface irregularities such as blow holes and profile defects may require patching with Armawall Filler or Patch prior to system application.

Application

Armawall Satin can be used in a number of ways:

1. Apply 1 coat by roller over other Armawall textures as a decorative dirt shedding topcoat (4m2/litre).
2. Apply 2 coats over primed concrete with a texture roller for a low profile finish (2m2/litre each coat).
3. Apply 2 coats over primed concrete with a roller or spray to achieve a smooth membrane finish (4m2/litre each coat).

Cleanup

Water, away from drains and watercourses.

Stirring

Stir Armawall Satin prior to use.

Temperature

Avoid application when temperature is below 10°C and above 35°C.