Armawall Tuscany Sand

Datasheet Number: D244

A pre-mixed, single component rendering material designed to produce a flat, relatively smooth sandy texture with the appearance of natural stone. Designed for applications including render and other masonry surfaces.

Product Overview

Description
A pre-mixed single component rendering material designed to produce a flat, relatively smooth sandy texture with the appearance of natural stone. Armawall Tuscany Sand can be overcoated with Armawall roll-on system e.g. Armawall Impact or Armawall Satin.

Uses
On fibre cement, concrete & previously painted surface. Thin section flexible render, ideal for difficult substrates, including fibre cement sheeting, previously painted surfaces, dense smooth concrete, AAC Hebel blocks and panels, plasterboard and polystyrene.

Features & Benefits

Economical
Provides a stable, solid and tintable base. There is no need to seal Armawall Tuscany Sand before application of finishing coats.

Extensive case history
Proven, performance in all climates.

Flexibility and compatibility
Tested and approved for use over Fibrous Cement sheeting and can be used on the majority of building substrates.

Fungicide protection
Protects against mould and fungus.

Natural render finish
Provides a natural coloured render finish, over a suitably prepared substrate for painting with Armawall roll-on.

Pre-mixed acrylic render
A user friendly single pack, free of lime and cement. Acrylic content provides strong adhesive bond to suitably primed masonry substrates.

Water vapour permeable
Allows substrate to breathe.

Technical

Colour Range	Off White.
Dry Film Thickness	1mm to a maximum of 4 mm.
Drying & Recoating	Armawall Primer – Recoat 2 Hours. Armawall Tuscany Sand – Recoat 48 Hours. Note: 1. Drying time may be lengthened in damp, cold or humid conditions. Under normal conditions application of Armawall Texture Coating Systems may be commenced 2 days after render. 2. Variations in colour may occur from batch to batch. Armawall Tuscany Sand should be ordered in job lots, unless variations in colour is required to achieve certain effect.
Odour	Low
Profile	Flat, relatively smooth render finish.
Spread Rate	Up to 1.7m2/litre @ 1mm average thickness. (Spread rates will be lower on rough or absorbent surfaces).
Storage Handling	Pails should not be stacked more than 2 high during transport and should not be stored in direct sunlight or below 4°C.

Surface Preparation

See comprehensive surface preparation instructions on the full datasheet available at: www.specif-i.com.au

Application

See comprehensive application instructions on the full datasheet available at: www.specif-i.com.au