Armawall Ultrafine –

Lambswool Roller

Datasheet Number: D212

A durable exterior acrylic designed to give a “cement render” effect and bridge hairline cracks in masonry surfaces. Designed for applications including tilt slab concrete and cement render. Not suitable for timber surfaces.

Product Overview

Description
A durable exterior acrylic designed to give a “cement render” effect and bridge hairline cracks in masonry surfaces.

Uses>
Brick, fibro, concrete, cement render, AAC panels and blocks and other masonry surfaces. DO NOT use on timber surfaces.

Features & Benefits

Low texture profile>
Contemporary render-like finish.

No primer required>
Economical 2 coat system rather than the usual 3 coat texture systems.

Technical

Colour Range	Available in a wide range of colours.
Drying Time	Armawall Ultrafine 4 Hours. Note: This may be lengthened in damp, cold or humid conditions. Do not apply at temperatures below 10°C
Odour	Low
Profile	Low
Specifications met	APAS 0117/3
Spread Rate	8m2/litre.

Surface Preparation

New cement render, masonry and concrete surfaces
New cement render, masonry and concrete surfaces should be allowed to cure for 28 days. Off form concrete should be thoroughly cleaned by acid etching, water or sand blasting to ensure all bond breaker oils are removed. Seal tilt slab concrete and CFC with Armawall Sealer/Bonder thinned 50% with GTA007 to ensure adhesion of topcoats.

Previously painted surfaces – in sound condition
Previously painted surfaces in sound condition should be scrubbed down with detergent and fresh water, fresh water washed and allowed to dry. Previously painted enamel surfaces Previously painted enamel surfaces should be undercoated with Taubmans Tradecoat. Surface irregularities such as blow holes and profile defects may require patching with Armawall Filler or Patch prior to system application. CAUTION: When applying Armawall Ultrafine on large tilt-up concrete slabs or unbroken high rise off form concrete, you will not easily be able to maintain a wet edge. This can cause overlaps to stand out.

Application

Armawall Ultrafine does not require primer except on Tilt Slab or CFC. Apply 2 coats of Armawall Ultrafine using a long nap roller.

Cleanup
Water, away from drains and watercourses.

Stirring
Stir Armawall Ultrafine prior to use.

Temperature
Avoid application when temperature is below 10°C and above 35°C.