Endure Walls

Available in: Low Sheen, Semi Gloss, Matt

Nanoguard Technology
Nanoguard® Advanced Technology

Taubmans Endure is engineered with Nanoguard® Advance, which provides maximum protection for your walls. It has an interlocking molecular structure that creates a protective shield so everyday dirt and stains can be wiped away without compromising the quality of the paint. It provides excellent mould and mildew protection so you have a cleaner and healthier home environment. It is one of the most advanced paint technologies available today.


Asthma Council Approved
Asthma Council Approved

Taubmans Endure Interior and Taubmans EasyCoat Walls have both been approved by the National Asthma Council Australia's Sensitive Choice Program. Products approved by the Sensitive Choice Program may help people with asthma and allergies.

8 in 1 Multi-Benefit Protection
8-in-1 Multi-Benefit Protection

PROVEN TO DELIVER SUPERIOR PROTECTION* WITH 8-IN-1 MULTI-BENEFIT PROTECTION:
Wash resistant 
Stain resistant
Scrub resistant
Anti-microbial
Asthma & allergy friendly 
Low VOC & odour
Inhibits mould & mildew
Nanoguard technology

Bacteria Shield
BACTERIA SHIELD

The advanced anti-microbial technology in the new Taubmans Endure Interior also sees it better equipped to protect homes against mould, mildew, and bacteria.

Low VOC
LOW VOC

Improved indoor air quality is a strong feature of the new Endure Interior range, with low odour, and VOC* levels reduced to 16g/m2.

Low Sheen
Ideal for all interior walls. Gloss Level 5-10%
Semi Gloss
Good for all interior walls, bathrooms, laundries and high traffic areas. Gloss Level 20-25%
Matt
Available soon

Surface Preparation
Ensure surfaces to be painted are clean, dry and free of contamination. Walls should be wiped down with a mild detergent and rinsed clean with fresh water, even if they don't appear to be dirty, to ensure removal of any surface contamination and ensure the paint has a clean surface to adhere to.
New Work
Seal new or bare plaster with Taubmans Prep Right Plaster Sealer. Seal bare wallboards or Gyprock with Taubmans Ultraprep or Taubmans 3 in 1.
Repaint
Remove all loose or flaking paint, wash all areas thoroughly to remove any surface contamination. Treat surfaces affected by mould with chlorine bleach diluted one part bleach to four parts water. Rinse clean with fresh water. Spot repair any bare areas such as filled holes as per directions for new work.
Coats
Apply two liberal coats by brush, roller or spray. Do not overspread. Keep brushes and rollers working freely by rinsing occasionally in clean water.
Clean up
Water wash up, away from drains.
Coverage
Up to 16m²/litre, depending on nature of surface. Coverage will be lower on rough or absorbent surfaces.
Recoat
Recoat after 2 hours at 25°C and 50% relative humidity.
Stirring
Stir paint with a 25mm wide flat stirrer in a circular lifting motion for at least 5 minutes before use. It is always recommended to stir paint before use to ensure that the colour tints are dispersed evenly throughout the paint.
Temperature
Do not use at temperatures below 10°C, above 35°C or when humidity is excessive.