Paint Prime

Low Sheen
Ideal for all interior walls. Gloss Level 5-10%

Coats over

  • New or repaired plasterboard and timber
  • Aged enamel
  • Dark colours

Surface Preparation
Surfaces must be clean, dry and free from all surface contamination and dust. Treat mould with bleach then rinse with clean water. Fill in the surface defects with suitable filler or sealant. Avoid using masking tape on wall and ceiling paints. Sand plasterboard joins to obtain a smooth uniform surface.
Remove all loose and flaking paint and ensure the surface is clean and dry. Lightly sand glossy or enamel surfaces.
Apply two coats by brush or roller.
Clean up
Water wash up.
Up to 16m²/litre, depending on nature of surface. Coverage will be lower on rough or absorbent surfaces.
Recoat after 2 hours at 25°C (allow 4 hrs in cold or humid areas).
Stir paint with a 25mm wide flat stirrer in a circular lifting motion for at least 5 minutes before use. It is always recommended to stir paint before use to ensure that the colour tints are dispersed evenly throughout the paint.
Do not use at temperatures below 10°C or above 35°C.