Easy to apply
Low splatter off the roller
Surface must be clean, dry and free from all surface contamination. Where applicable, fill cracks with a suitable filler then sand and dust surface down. Prime and or undercoat surfaces with appropriate products as required.
Previously Painted Surfaces
Remove all loose and flaking paint by scraping or sanding previously painted areas and sand smooth. Surfaces must be clean, dry and free from all surface contamination. If mould is present, treat with bleach then rinse clean with fresh water. Spot prime bare areas with a suitable primer or undercoat. If painting over enamel surfaces, sand thoroughly and apply one coat of oil based undercoat or other suitable product to promote inter-coat adhesion.
Check colour before use. Box individual cans before use.
Preparation Products – Apply one coat by brush, roller or spray.
Finishing Products – Apply two even coats by brush, roller or spray.
- Stir paint in a circular lifting motion for 5 minutes before use
- Drying time: 30 minutes (touch dry)
- Recoat: 2 hours at 25°C (allow 4 hours in cold or humid areas)
- Do not paint at temperatures below 10°C
Up to 16m² per litre. Coverage will be lower on rough or absorbent surfaces.
Ensure adequate ventilation. Keep floors and furniture covered. Keep the lid on containers when not in use.
Scrape excess paint from equipment into a separate container. Wash up with water. Do not dispose of paint or wash water in drains or sewers. Avoid exposure to steam for 48 hours.