Tradex Oil Based Enamel

Ideal for interior and exterior surfaces subjected to heavy wear such as doors, handrails and roller doors.
Semi Gloss
Ideal for high traffic interior surfaces such as window frames, doors, door jambs and skirting boards.

Resists abrasions
Hard wearing
Smooth finish

Gloss level
Gloss: Over 85%
Semi-Gloss: 40% - 50%
Up to 16m² per litre
16 hours
Mineral Turps
Specifications Met
APAS 0015/1 approved

Surface must be clean, dry and free from all surface contamination. Treat mould with bleach then rinse with clean water. Fill in surface defects with a suitable filler or sealant and sand smooth

Stir paint well in a circular lifting motion for 5 minutes before use with a broad flat paddle. Apply one coat of Tradex UltraPrep (where required) and two coats of Tradex topcoat (Ceiling, Matt, Low Sheen or Semi-Gloss) by using a good quality brush and roller sleeve (12mm for Ceiling, Matt & Low Sheen; 8-10mm for Semi-Gloss). Extra coats may be required for application by brush only. It is also important to avoid using poor quality or worn rollers and brushes as they can adversely affect the final finish. Spray Application: Airless Spray or HVLP. Thin up to 10%.

  • Stir paint in a circular lifting motion for 5 minutes before use
  • Drying time: 6 hours (touch dry)
  • Recoat: 16 hours at 25°C (in cold, damp, or humid conditions, drying time may be lengthened)
  • Do not paint at temperatures below 10°C

Approximately 16m² per litre depending on the nature of the surface. Coverage on rough and/or porous surfaces will be lower.
Oil based enamel paints yellow under certain conditions. Contact Taubmans Customer Service Department on 131 686 for details. To prevent yellowing on interior surfaces and to avoid solvent odours, use Taubmans Endure Doors & Trim, in place of oil based enamels. For superior colour retention on external surfaces use Taubmans Endure Exterior.
During Painting
Ensure adequate ventilation during use. Keep floors and furniture covered. Keep the lid on containers when not in use.