Water Based Enamel Paint

Ideal for all interior & exterior doors and trim. Gloss level 80%.
Ideal for all interior doors and trims. Gloss level 40% - 50%.

Surfaces must be clean, dry & free from all surface contamination. Treat mould with bleach then rinse with clean water. Fill in the surface defects with suitable filler, putty or sealant. Avoid using masking tape on wall and ceiling paints.
New Work
Paper faced plasterboard, masonry & timber: apply one coat of Taubmans 3 in 1.
Previously Painted Surfaces
Remove all loose and flaking paint and sand glossy or enamel surfaces thoroughly with fine paper. Prime bare areas with Taubmans 3 in 1. To ensure an even surface when painting over patchy or contrasting colours apply Taubmans 3 in 1. For previously painted enamel surfaces undercoat with Taubmans 3 in 1.
Confirm colour before use. Apply two coats using a 5mm (length of a nap or pile) roller or good quality brush. Avoid thick coats as this will cause runs to appear. If painting a large flat trim area, such as a door, apply a roller for best appearance.

  • Stir paint in a circular lifting motion for 5 minutes before use
  • Drying time: 30 minutes (touch dry)
  • Recoat: 2 hours at 25°C (allow 4 hours in cold or humid areas)
  • Do not paint at temperatures below 10°C

Up to 16m2 per litre. Coverage will be lower on rough or absorbent surfaces.

Approved by Sensitive Choice
Approved by Sensitive Choice Taubmans Water Based Enamel is an approved product in the National Asthma Council Australia’s Sensitive Choice® Program. Products approved by the Sensitive Choice Program may be a better choice for people with asthma and allergies.